Edius Transition Problem

C

colin rowe

Active member
I have a problem with Edius 4.5. When I place any transition , other than stretch or dissolve on the timeline it starts, 2 or 3 mm into the outgoing video, ie not to the outside edge of the video. It gives the impression of cutting into the outgoing clip leaving a portion of it all the way round on sreen. It also renders out as such, and the edge problem records to tape and shows up on the TV. I have installed the demo of version 5 and this does the same. Any ideas appreciated
 
Can you give couple of screenshots what exactly is happening with which transition (2D, 3D etc, and exact one), I don't really understand from your post. Over here Edius transitions work fine all the way.
 
Colin,

after applying the transition, go to the info dialog, double click the icon of the applied transition to open its setting dialog box. Find the general tab, uncheck the "enable overscan handling" box.

Ted
 
That overscan setting....who uses that anyway? Its the first thing I deselect when I use a new transition. I see no use for it at all.
 
First sorry for my English,second when edius it's started in preset settings in window You must change "save area" or something like that always it's set on 3% you must change to 0%.I hope You understand me if not I'll send You tomorow screen shot
reguards
 
You must log in or register to reply here.
Back
Top