Easom Aerospace
Active member
Ok! I think things just got better. I have been trying to make this cage and adapter project my own little venture. Trying to keep the cost down and play around with it some. Shaving off expense by water jetting and such. I was under the impression that film makers (like I have become after spending much time here.) wanted fast and cheap. I'm finding the opposite. Precision and quality outweigh the other aspects. So. I've put the project into our regular line with all the precision stuff. Properly machined and quality checked.
The parts are fully machined to 1/2 a millionth of an inch tolerance. Give or take. lol. Leaving room for the Anodizing of course. All of the threads are inserted Stainless steel for a lifetime of use. The new spacers have side rail mounts that can be used for mounting accessories or even the Amazing Micro MatteBox from Redrock with our spacer adapter.
The Easom Adapter is being Re-Vamped as well with full machined back focus adjustment and a mini adapter also for the Vixia family.
The only expense to making the parts this way is, well the expense. The new line of spacers is approx 1 inch taller than our 1st sets to accomodate the full camera inside the cage. Even HVX or PMW. The bottom line is $495 USD per set. 2 large rail spacers with all hardware for top, bottom, and side rails. The dual handle mount (2 triangles) all clamps and knobs. The set does not include any Rods. I'll be posting to Ebay today with full specs. Thanks to all who made these possible, Including dvxuser.com. Cory
The parts are fully machined to 1/2 a millionth of an inch tolerance. Give or take. lol. Leaving room for the Anodizing of course. All of the threads are inserted Stainless steel for a lifetime of use. The new spacers have side rail mounts that can be used for mounting accessories or even the Amazing Micro MatteBox from Redrock with our spacer adapter.
The Easom Adapter is being Re-Vamped as well with full machined back focus adjustment and a mini adapter also for the Vixia family.
The only expense to making the parts this way is, well the expense. The new line of spacers is approx 1 inch taller than our 1st sets to accomodate the full camera inside the cage. Even HVX or PMW. The bottom line is $495 USD per set. 2 large rail spacers with all hardware for top, bottom, and side rails. The dual handle mount (2 triangles) all clamps and knobs. The set does not include any Rods. I'll be posting to Ebay today with full specs. Thanks to all who made these possible, Including dvxuser.com. Cory
