DVX100A audio distortion/narrow "sweet spot" issue

Jai

New member
Since I've bought my DVX100A I haven't had many opportunities to use it in situations where audio was a main factor.

Recently did a shoot where I worked with an experienced audio tech who was running a mixer and line to my camera (setup included boom mic, set, actors) as well as recording a DAT backup version.

We were baffled by the narrow range between good, solid audio, and the sound to tape going into distortion too easily (was fine on the DAT, fortunately.)

We tried at -50 and -60 settings, adjusting the level inputs, but the problem vexed us throughout the shoot. Setting the ALC to "on" seemed to help a bit, but did not eliminate the trouble completely.

Anyone else experienced this problem? Ideas? Advice?

Jai
lgf@lanset.com
 
What mic and mixer? Was the mixer sending out line level? Was the DAT coming off the tapeout or was it split cables? Did you try an in-line attenuater?
 
the audio set up used

the audio set up used

(Info from the audio guy on the shoot) :

> What mic and mixer?

The mic- Soundfield ST 250

The recorder/mixer- Fostex PD6

Wabbit:

>Was the mixer sending out line
> level?

Yes. We started line level at +4 db and then dumbed it down to -10db.
However our +4db line level and same settings work fine with the 100,
just
not the 100A.

>Was the DAT coming off the tapeout or was it
> split cables?

See above response.

>Did you try an in-line attenuater?

Yes. See above response.
 
looks like the Camera was set up to record mic levels on the XLR in!!! I did the same thing submixing live music bands on 4 DVX100A each receiving 2 tracks of audio.
Calibrated them all with the same -20db tone (adjusted the mic line switch on the one that were not properly adjusted, and then that was it!!!
Matnik
 
+48 was on...

+48 was on...

At this particular shoot, I left the audio settings to the pro sound guy while I tried to solve the problem of what to do with the three 650's (!), with no screens or gels, that the neophyte director had rented (against my advice) for a night shoot in a 8x12 room featuring five adult actors moving about. (Let's just mention here that one of the props was a raw trout and by wrap, it was essentially cooked.)

That said, when the sound guy mentioned later the distortion-to-tape issue, I asked him if the +48V mic power had been set (incorrectly!) to "on." He swore on a copy of Michel Chion's "Audio-Vision" that those switches had been set to "off."
Since I had never had audio distortion problem with my camera (unless I failed to monitor, screwed up and had settings too hot) we got together for an audio test with the camera.

To the sound guy's chagrin, I was right. The +48V mic power had been left on, and worse, he had changed the switch himself, after I had turned them off in preparation, knowing what audio system we would be using.

I worked with another director on an interview with a wireless lav mic a few days ago and I had to catch him when he nearly did the same thing-- reached over my shoulder saying, "Oh, these should be set to 'off'," while proceeding to actually turn them on! I don't know if the off/on configuration is an optical illusion for some on this camera, but it's always worth double-checking.
 
Back
Top