Batch rotation in FCP after using Brevis

[gfok]

Hello, I am a new member, just finished shooting a low budget feature with HVX200 usinf Brevis 35mm, love the result.
Got a little question, In FCP, how could I flip back all thethousands of footages at once instead of assign them on by one, I've been looking and looking still can't figure it out.
Many thanks in advance.

 

[Oedipax]

I'd like to know this too. I remember there being a software utility to flip 35mm adapter footage a while back, but I haven't been able to find it since I got my adapter. Temporarily I've just added the Flop filter (with Horizontal + Vertical pre-selected) to my effects favorites. You can drag it onto as many clips as you have highlighted in the timeline, so it's not so bad. But it'd be great if there was a way to do this before going into FCP so I wouldn't even need the extra filter.

By the way, I tried doing the flip in Quicktime Pro and saving that out, but what happens is when you preview the footage on the FCP timeline, it's still upside down and backwards, then when you render, it's right-side up (assuming you didn't add a flop filter to it). So it's kinda the worst of both worlds.

 

[gfok]

Thanks for the info! Best Regards.

 

[Zak Forsman]

to apply the flop filter to more than one clip... "COPY > Paste Attributes > Filters" is your friend.

 

[Beat Takeshi]

hmmmmm. in Avid you make a bin and import it all to the time line and flip. Then you use that bin to mark your in and outs in a new timeline. Does FCP allow to layer like that?

 

[gfok]

Again, thanks for all the good tips!! Regards.