Advice for first time recording

craigom

Member
We are new to audio and have a project next week where we will be shooting interviews with people on the floor of an exhibition, so we expect there to be quite a bit of ambient noise - voices, people passing, music etc. I of course would like to isolate the speakers voice as much as possible and cut out this ambient noise - but we have limited budget and equipment. We have the Oktava MK-012 set with 3 caps (Hyper, Cardioid and Omni) that will be feeding directly into a HVX200. Any tips on what we can do to get the best sound quality? Some questions:
- Is a boom totally necessary? Does it make a huge difference from which angle the mic is pointing at the speaker? Should it always be from above?
- Is the hyper cap on the Oktava a decent option or should we look at getting another Shotgun mic?
- Does using a mixer make a big difference in the reduction of ambient noise?
- Is a BBG and Windjammer necessary if we are shooting indoors?

I would be willing to spend a few hundred bucks on some additional equipment if it would help so if you have suggestions, would be grateful.
 
We are new to audio and have a project next week where we will be shooting interviews with people on the floor of an exhibition, so we expect there to be quite a bit of ambient noise - voices, people passing, music etc. I of course would like to isolate the speakers voice as much as possible and cut out this ambient noise - but we have limited budget and equipment. We have the Oktava MK-012 set with 3 caps (Hyper, Cardioid and Omni) that will be feeding directly into a HVX200. Any tips on what we can do to get the best sound quality? Some questions:
- Is a boom totally necessary? Does it make a huge difference from which angle the mic is pointing at the speaker? Should it always be from above?
- Is the hyper cap on the Oktava a decent option or should we look at getting another Shotgun mic?
- Does using a mixer make a big difference in the reduction of ambient noise?
- Is a BBG and Windjammer necessary if we are shooting indoors?

I would be willing to spend a few hundred bucks on some additional equipment if it would help so if you have suggestions, would be grateful.

With a lot of ambient noise, the closer you can get your microphone to the subejct the better the results you get. If you have an interviewer (I hope that's your plan - I hate it when the camera operator is shouting questions at the subject) working in front of the camera talking to your subjects, you might want to abandon the idea of a boomed mic altogether and put a reporter's stick-mic such as an EV RE-50 or EV 635b into the hands of the person doing the interviews. If you do want to use a hyper or a shotgun, swinging a boom in such confined spaces might be a problem and getting a pistol grip might be a good idea. The shotgun would give more off-axis noise rejection than you'll get with the Oktava hyper capsule, plus Oktavas have a reputation for handling noise. Definitely use the foam windscreen on whatever mic you choose but the ballgag and windjammer probably will be overkill. Finally, a small field mixer can do a lot of things for you but ambient noise reduction isn't one of them and in this situation just adds another cable for people to trip over.

IMHO, the optimum setup for this kind of run-and-gun interview would be a hand-held stick mic with a wireless transmitter, wireless receiver mounted on the camera. Hard-wired stick mic would be number two choice. Gun in a pistol mount number 3 with hyper number 4 and boom options in last place. As usual, any on-camera options are not likely to work very well at all.
 
Thanks very much. So if i understand correctly, the Okatava is not a bad option in this situation, even in comparison to a shotgun mic. We will stick with the Oktava mic for now and we will try and get the mics as close as we can. I assume the Hyper is a better option than the cardioid, even if we are getting the mic close? Thanks again for your input
 
Thanks very much. So if i understand correctly, the Okatava is not a bad option in this situation, even in comparison to a shotgun mic. We will stick with the Oktava mic for now and we will try and get the mics as close as we can. I assume the Hyper is a better option than the cardioid, even if we are getting the mic close? Thanks again for your input

The hyper would be much better than the cardioid because it's narrower angle of acceptance means it will reject surrounding noise better. A shotgun is even narrower. The reason for tha admonition you often hear about not using 'guns indoors is because of their behaviour in a reflective environment but I doubt that would apply here. So in this environment, all other things being equal the shotgun would give you the most isolation with the hyper number 2. A cardioid would be third while an omni on a boom wouldn't even be in the running. The Oktava's have a reputation as a good mic performing well above what you would expect at their price point but they do have a rep for being subject to a lot of noise when hand-held. As mentioned before, it may be difficult as well as dangerous to swing a boom overhead in the middle of a crowd of exhibition attendees while having the mic at the camera position isn't likely to work well at all. The RE50 I suggested, held 8 inches from the interviewee's face by the interviewer, will be close enough to capture the voice well and isolate it from the surrounding din even though it is an omni mic and otherwise not a good option plus it has very low handling noise as it is designed for exactly that application..
 
All reporter handhelds are omnis, bacause:

- They have no proximity effect (no bass loss/boost depending on the distance)
- They have the least wind noise
- They have the same "sound" no matter which way they are pointed

Like a good lavalier then, and they are all omnis, too. For that reason you have to stick the mic near the mouth and show it in the picture, really the only dowside to all this.

If that doesn't work use a short shotgun with softie and a pistol grip.
 
Another quick question....when using an external mic for interviews is it best to record audio using 2 channels on HVX200? We have the option to record to Ch1 and Ch2 using the external mic but i am not sure if there is any benefit to doing that. Advice?
 
Another quick question....when using an external mic for interviews is it best to record audio using 2 channels on HVX200? We have the option to record to Ch1 and Ch2 using the external mic but i am not sure if there is any benefit to doing that. Advice?
One trick that can help when the subject's volume jumps all over the place is to record to both tracks with one track about 8 dB lower than the other. That way an unexpected loud noise the clips the louder track may still be usable on the other
 
Ah thats a great tip. Thanks. Now i just have to figure out how to reduce the volume input on one of the channels. We use the hvx200.
 
Just a follow-up post. We used the hyper cap on the Oktava mic and it worked pretty well. We are pleased with the results, considering the very noisy environments we were recording in. We always recorded a 20 second sound print of ambient noise with our interviews so we should be able to reduce the ambient noise level somewhat in post. But the Oktava worked well. One thing we learnt. Make sure you always have a spare mic cable! We luckily brought one along as we had noise issues with one.
 
Back
Top