Loud Static/Audio Clipping at end of Capture

B

brandtb

Active member
I recently bought a a Panasonic AG DVX100B and the Prem Pro CS3 (prev. I have done just a little video work with MovieMaker and a smaller Pan. camcorder - somewhat of a novice). I just started capturing clips in PPro via Firewire and invariably at the end of the clip capture there is a VERY loud rapid fire static for about five to nine frames or so - ending with video of a frozen or slightly stuttering final frame. Some times there is a slight pop at beginning of capture but this is rare. I have a Dell Dim. 8250 Pentium 4 - 2.8 Gig processor with 2Gigs of ram. Radeon 9700 Pro video card (latest drivers) and just installed a brand new Sound Blaster XFI sound card. I spoke with Adobe and they hadn't heard anything like this related to camcorder...hence this post.

I can of course trim this noisy stuff off the end, but I sure would like to to know just what exactly is going on...any help would be much appreciated. Will send AVI file if requested
 
I have had a similar problem; I think that it has something to do with time-code not registering. It only happens when there was a break in the shooting (the camera was turned off and then back on to continue shooting). I'm not sure what to do about it. i usually just edit it out.
 
thanks...your experience sounds same too

thanks...your experience sounds same too

As well, it happens where there is a "break" either from pausing or stopping the camera
 
You must log in or register to reply here.
Back
Top