DVX100be+SGpro+Nikon 24mm f2.0+Nikon 50mm f1.2

iposiniditos

iposiniditos

Well-known member
Hello guys,

one new test with this setup:

dvx100be
SGpro
Nikon 24mm f2.0 (at f4.0)
Nikon 50mm f1.2 (at f4.0)

Settings:
Detail Level +7
V.Detail Level +7
Detail Coring +7
Chroma Level 0
Chroma Phase 0
Colour Temp 0
Master Ped -5
A. Iris Level 0
Gamma Cinelike D
Matrix Norm1
Skin Tone Detail OFF
V Detail Freq Thin
25p

130secs, H264, 9.7mb

clip

Ofcourse any feedback is more than much appreciated!
:)
 
Lookin good. Shots look pretty sharp with that setup...

Love the "walking towards the camera" shot.
 
iposiniditos.. Very nice footage! You made me want to get an adapter! Actually.. I already wanted one.. but you just enhanced it! :)
 
Very nice, I like the edge to edge sharpness. I;ve often observed the higher the f-stop on the actual camera, i.e. F4 on the dvx100 results in an even sharper image.
 
Yeah, this is some really great material, very sharp. What made you decide to go with the SGpro?
 
I've always been scared to bump up the sharpness in camera that much, but I think I may give it a go after seeing this. Very, very sharp and nice looking.
 
Thanks a lot guys. Much appreciated.

@-D- : Wayne's support is great and he always trying to push things to the limits. He seems to me so perfectionist.
 
HEy man this is carrying over fomr the thread in the Sgpro forum but,
i learned a trick from Barry green. Turn the Detail coring down to 0, avoid extremees. Apparently it reduces the sharpness of the picture over all. you can get some additional sharpness that way.
 
Great looking footage!

In your original post I see you said "at F4.0" by each of your Nikon lenses which makes me think that you set the lens at F4.0 but in another post someone states that the camera was set to F4. Sorry if I'm asking you to clarify the obvious but I just want to be sure: camera or Nikon lens at F4? :dankk2:
 
You must log in or register to reply here.
Back
Top