what wires/cable to get?

fdsa

Active member
Hi, I bought the firewire 410 and am getting the M-audio BX5 speakers. Like to know what kind of wires/cable should I get for the speakers? 1/4" to 1/4"? or 1/4" to XLR? and what brand? seems like monster is popular... but expensive, anything better? or less expensive but as good? thx need to know b4 buying.... :undecided
 
Hey good question. My BX8a's and firewire 410 are siitting in a box while I figure out how to rework my editing station to fit it all on here. Gonna build some shelves I guess, but wiring will be the next challenge.
 
Sure, Monster is good, but it's also expensive. If you don't mind a little extra work, you will get equally impressive results by soldering your own cables (I have all my audio cables custom made, and they are excellent). That way you can get a precise length too.
 
So what wires to get? I see theres studio wires, speaker wires, intsrument wires, etc etc.... man so much work just to get some wires..... what to get anyone?
 
Go with monster if you can afford it... now NEVER ever run a strait 1/4 to xlr or xlr to 1/4 cable without a converter, available at radioshack for 15 buck, and just as good as the 80 dollar ones everywhere else, though not quite as good as the 140 dollar ones.... point is it's one hundred times better than running a strait 1/4 to xlr cable. everyone has got to learn not to run those cheap 1/4 to xlr plugs, balanced xlr should be what the cable is since it's better to have cable runs in balanced xlr than unbalanced 1/4... then if you must, convert it to 1/4 right as it goes into the 1/4 device. A xlr 25 dollar cable will be better quality sound in total than a 60 dollar 1/4 phone plug. music cables are great... they have full dynamic range since they're made for high pitched guitar whinning and low thumping basses, and if it's a good quality cable it has an amazing amount of sheilding on it, very important when you have cables next to one another like you would both on stage and when setting up a desk, power cables can create interference... good luck, as long as you know the difference between balanced and unbalanced you'll do fine.

RaspyBunk
 
Basically, the 410 Only has unbalanced outs, so your best bet is a 1/4" to 1/4" unbalanced TS (not TRS!) cable.

And, dare I say it, operating at line level over relatively short distances... you won't see much difference between cheap and expensive cable.

RaspyBunk - be careful! As long as a 1/4" to XLR cable is TRS, it's the best thing for connecting 1/4" balanced to XLR. It's only a few crappy 1/4" TS to XLR cables that can cause problems. And since fdsa's outputs aren't balanced to begin with, there's really no point to anything besides 1/4" TS to 1/4" TS. An XLR cable WON'T sound better....

-Barry
 
what is TS cable? and I don't know the difference between balanced and unbalanced...but I just ordered the monster studiolink 500 series cables 1/4 to 1/4" and the mogami silver series mic cable 25' , how will these work for my setup? or shall I get the conquest cables which is 2x cheaper?
 
Sigh... Barry is of course right, the headphone jacks are trs, not the lines. And there are balanced 1/4 to xlr cables, unfortunately I always think in terms of what i can grab at radio shack or the music shop right by here. As far as definitions for you, There is balanced trs 1/4 phone cable... Balanced as compared to unbalanced (ts): Balanced has 2 audio lines and one ground... unbalanced has 1 audio line and one ground. The balanced saves your sound quality especially over long runs. like barry said it doesn't make much difference over short distances, to most people, none. and, if you start out unbalanced you should run it the length unbalanced like barry said. So listen to Barry and pretend I never said anything except good luck.
 
fdsa - TRS = "Tip Ring Sleeve" - like most headphine plugs, there are 2 black (non-conductive) bands separating the plug into a tip, a ring, and a sleeve. Mono, unbalanced cables - TS or "Tip Sleeve" have just 1 black band separating the plug into two parts. In radio shack lingo, TRS is "stereo" cable and TS is "mono" cable. Hopefully, your vendor should be able to tell you if the particular StudioLink cables you ordered (they make lots of different kinds) are TS (unbalanced) or TRS (balanced). Again, you won't see much difference if any between Monster and cheaper cables in this application. Mogami mic cables are excellent (GOld better than silver, but silver's pretty good!) and will do fine for getting mic signals into your 410. For the mic cables, you're much more likely to notice a quality difference, so I'd stick to the Mogamis.


Don't worry raspy, that was good advice, just not necessarily applicable to the 410...

-Barry
 
o o o....... I see.... so, should I be getting stereo sound(TRS) cables? or mono(TS) cables? should be stereo right? I ask the musician's friend guy about those studiolinks, he said they are unbalanced..... mono sound? is this what I should be getting? @@
 
Back
Top