External Mic Setting on DVX100b

Whats up Everyone,
I went with the Rode NTG-2 shotgun mic and have a couple of questions that I hope some of you could answer. Do I set the audio and 32k or 48k? When I editwe convert all audio to 48k(on Avid editing system). Does that mean I should record my audion on this setting to? I know if you are specifically audio dubbing, the manual says to set it to 32k. And with the rode NTG-2 mic do I need the AA battery to power up the mic or will the XLR cable power it also?
Thanks for your time everyone
Joe
 
NEVER record at 32k! It is reserved for 4 channel on-camera recording or dubbing which is NEVER used by professionals. If they need more than 2 channels a separate recorder is used (at 48k).

Some editing systems do not even capture the audio if recorded at 32k.

All dubbing etc is done with the editing program, where you can add as many channels as you want or need, or more...

Rode NTG-2 does not need the battery with DVX100 if you turn the 48v mic power on (switch upper right corner behind the LCD screen).
 
Thanks a lot for your help Petrus,
I will make sure I leave my setting at 48k. One more question if you dont mind,...
Does this mean i can still plug my wireless lav system into Input 2?(XLR)...and record whoever has the lapel mic and record from my Rode NTG-2?
Thanks for your help again.
 
You can attach separate mics to channel 1 and 2 (like wireles lapel mic and shotgun) and if you have the routing switces set right mic 1 goes to ch1 and mic 2 to ch2. Also possible to use one external and buit-in mic at the same time, or route ch2 mic to both channels (normal prosedure when using shotgun only).

Just whip out the manual and test all possible combinations.
 
Thanks Petrus.
I was looking at the manual last night and thats why i got confused with the 32 & 48k setting.
When I use the Rode mic, do I turn off the internal microphone on the camera to? I really do not want to use the internal mic.
Thanks for all your help
 
Back
Top