filmmaker77
10-15-2007, 09:51 PM
I just finished editing a commercial shot in 720p on the HVX200. I mistakenly cut it in an improperly set up FCP 4.5 sequence.
When I went to export it was squeezed and elongated. To test, I dropped a clip from the original footage into a new sequence and it came up as a whole set of different presets and was in the proper ratio.
Grrrrrr.
Is there a workaround/way to change the sequence's settings to make it work, so I don't have to re-assemble this project in a new timeline/sequence? There are quite a number of cuts.
When I tried to make changes, it severely screws up the picture, stretching it and squeezing it.
Help.
When I went to export it was squeezed and elongated. To test, I dropped a clip from the original footage into a new sequence and it came up as a whole set of different presets and was in the proper ratio.
Grrrrrr.
Is there a workaround/way to change the sequence's settings to make it work, so I don't have to re-assemble this project in a new timeline/sequence? There are quite a number of cuts.
When I tried to make changes, it severely screws up the picture, stretching it and squeezing it.
Help.